tallbike'a How to build? DIY part 1 
first We begin by gathering the necessary junk-mtb frames, old Romety Waganty. Generally, it is important that the top frame had a good bottom bracket and seatpost niezapieczoną, lower fine if you have long hooks and smooth controls.
second Hierachię-what we set down at the top and unscrew the useless crap.
third We are looking for Dr. Evil-Spawacza entire operation! It was from him depends largely on the success of the operation.
4th In the bottom frame, install the extension fork steerer tube.
5th When wspawywaniu tube should remember to keep the thread in such a condition to be able to counter the reins! Everything nice smear and tighten, it is difficult to tighten the nut loosened the headset sitting on her feet:)
6th It is recommended to use goggles and gloves.
7th To all the weight was not based on the steering tube is worth the additional rod welded between the top tube and inclined tube.
8th It should cut off the protruding parts for maximum contact area between the frames. All of the bonded areas deprive gumówką paint.
9th Bicycle stand, it appears invaluable in such cases.
10th Do not look in the sun!
11th It happens that the material is a little hot. Be sure to have when you've got a bit of snow or water.
12th In the next Daft Punk colleagues tell us how to solve the drive and how to get on this contraption.
first We begin by gathering the necessary junk-mtb frames, old Romety Waganty. Generally, it is important that the top frame had a good bottom bracket and seatpost niezapieczoną, lower fine if you have long hooks and smooth controls. 
second Hierachię-what we set down at the top and unscrew the useless crap. 
third We are looking for Dr. Evil-Spawacza entire operation! It was from him depends largely on the success of the operation. 
4th In the bottom frame, install the extension fork steerer tube. 
5th When wspawywaniu tube should remember to keep the thread in such a condition to be able to counter the reins! Everything nice smear and tighten, it is difficult to tighten the nut loosened the headset sitting on her feet:) 
6th It is recommended to use goggles and gloves. 
7th To all the weight was not based on the steering tube is worth the additional rod welded between the top tube and inclined tube. 
8th It should cut off the protruding parts for maximum contact area between the frames. All of the bonded areas deprive gumówką paint. 
9th Bicycle stand, it appears invaluable in such cases. 
10th Do not look in the sun! 
11th It happens that the material is a little hot. Be sure to have when you've got a bit of snow or water. 
12th In the next Daft Punk colleagues tell us how to solve the drive and how to get on this contraption. 
0 comments:
Post a Comment